Smooth cast iron plate

Pose :

Stabilize the ground plate with a bed of sand if you are laying it on bricks, stone or if you embed it.

Allow a space for expansion around the perimeter of the smooth cast iron plate (equivalent to 1cm per meter depending on the dimensions of your plate.

Use :

Do not make the first fire directly on the smooth plate. Place a 3 to 5 cm bed of ash, sand or sawdust to avoid a thermal shock that would break or weaken the smooth cast iron plate. Likewise, this process is mandatory when your fireplace has not been in operation for 1 to 2 weeks.

Never extinguish your fireplace with water.

It is nevertheless essential to use logs of 100 cm for large cast iron plates, above 90 cm.

Interview :

At the end of the season, take a fine and flexible wire brush, brush the smooth cast iron plate well so that it regains its original appearance. Then pass over the entire surface a new black "Zebraline" type protection or similar.

Guarantee :

Smooth cast iron plates are guaranteed "at first fire" within a time limit of 12 months, up to a width of 130 cm and subject to proper use.


Decorated fireback

Pose :

Seal the fireback with RYBACKI fasteners, leaving a 1 to 5 mm beating in both width and depth for expansion.

Use :

Build the first fire gradually and across the width of the fireback in order to avoid a significant thermal shock, and this each time your fireback has been 1 to 2 weeks without fire. It should be noted that a fireback that is poorly heated on the first fire and of irregular use becomes extremely fragile.

Never extinguish your fireplace with water.

It is important to scrupulously follow the recommendations for use for any fireback whose width exceeds 90 cm, knowing that the core of the fire does not exceed 55 cm, regardless of the size of your fireplace.

It is nevertheless essential to use logs of 100 cm for large fireplaces, above 90 cm.

Example :

Plate 50 to 70 cm wide: logs 50 cm.

Plate 70 to 90 cm wide: logs 80 cm.

Plate width greater than 90 cm: logs of 100 cm.

Interview :

Our firebacks are protected for the first few uses with a special paint that prevents soot from adhering. At the end of the season, take a fine and flexible wire brush, brush the plate well so that it regains its original appearance. Then pass over the entire surface, and particularly in the area of ​​the heart of the hearth, a new black "Zebraline" type protection or similar. Indeed, the resistance of the plate depends on its regular maintenance. And the addition of carbon by this product prevents it from disappearing into your plate.

Guarantee :

Decorated firebacks are guaranteed "on the first fire" within a time limit of 12 months, subject to proper use.


Guarantee and condition

Guarantee :

Your RYBACKI plate is guaranteed "at the first fire" within a time limit of 12 months from the date of purchase by the end customer, the receipt being proof. This warranty excludes any use contrary to the rules of good use as explained in the advice for use and maintenance (see advice from the craftsman Founder). In any case of complaint, you will be asked to attach proof of purchase.

As part of a standard exchange, the plate must be sent back to the RYBACKI FOUNDRY in order to carry out an assessment and to judge the validity of the warranty conditions.

Transport costs during a replacement:

The costs of returning to the RYBACKI FOUNDRY for expertise are the responsibility of the customer.

These will be reimbursed in the event of an expert appraisal in favor of the customer and a standard exchange of the defective plate.

Note: Like any wear part, a fireback has a limited lifespan: 5 to 10 years depending on its use and maintenance.